- How to Replace a Light Fixture With a Ceiling Fan | how-tos | DIY
- Install It
- How to Install a Ceiling Fan
- How to Wire a Fan & Light With Black, White & Blue Wires
- Option #2:
I am wanting to have the light and fan controlled by two smart switches. The switch labeled light has the red return hot going to the black of the fan, and the switch labeled fan has the white taped return hot going to the blue of the light. To operate the light and fan independently I must use the remote. Is that accurate or just builder BS to an inexperienced female? I have two switches at the wall and a 3-wire with ground cable similar to figure 4b but my power supply is at the switches, not the ceiling fan junction box.
How would I wire this scenario? Menu Skip to content. Join our newsletter and get the latest tool reviews every week! Download WordPress Themes Free.
How to Replace a Light Fixture With a Ceiling Fan | how-tos | DIY
Installing a Ceiling Fan January 14, 0. Once the lights are on, flip each switch until you switch off the power in the part of the house where the fan is located. That switch most likely controls the power to your fan. Read the instruction manual that came with your fan. Some fan models have special warnings or instructions that you need to read before you start installing it.
Install It
Read the entire manual to make sure you're installing it correctly. Identify the individual wires coming out of your ceiling.
There should be a white, copper or green, and black wire coming out of the ceiling's electrical box. Some setups will also have a blue wire, which powers the lights on your fan. The white wire is your neutral wire, the copper wire is the grounded wire, and the black wire powers the fan.
If you have a blue and black wire hanging out from your ceiling, you should also have 2 switches on your wall. Examine the wires coming out of your fan. Your fan should have a green, white, and black wire coming out of the top of it. If your fan also has a light, it will have a blue wire. There should also be a green grounding wire attached to the fan bracket itself. Screw the ceiling fan bracket into the ceiling.
How to Install a Ceiling Fan
Thread the wires coming out of your ceiling through the center of the bracket so that they hang freely below it. Place the screws that came with the bracket into the holes and turn them clockwise with a screwdriver to tighten them. This should attach and secure the fan bracket to your ceiling. Hang the ceiling fan in the bracket. Slide the top of the ceiling fan into the groove in the bracket and hang it. Fans will have different setups and brackets, but all modern fans will allow you to hang the fan on the bracket so that you can connect the wires.
Strip the ends of the wires.
How to Wire a Fan & Light With Black, White & Blue Wires
To connect your wires, the copper ends must be exposed. Remove the plastic caps that are on the ends of your wires. Use a stepladder to reach the wires in your ceiling and carefully cut away the plastic coating about 2 inches 5. Snip the plastic and slide it off to expose the copper wires. Repeat the process on the wires coming out of your fan. Twist both white wires together. The white wires are your neutral wires.
Connect the white wire coming out of your ceiling to the white wire coming out of the top of the fan. Twist the copper ends together until they are securely connected to each other. You may want to wear thick gloves to prevent yourself from getting cut on the copper. Connect the 2 green wires together.
Typically, a green wire is attached to your fan bracket and the other green wire is attached to the fan itself. Twist the copper ends of the wires together to connect them together.
Option #2:
Leave the green or copper wire that's coming out the ceiling unattached for now. Connect the black and blue wires in your fan if you only have 1 switch. Connect the black and blue wires coming out of your fan. This will allow you to control your fan and lights with a single switch.
Twist the copper ends of the black and blue wires together like you did with the previous wires.
